PolyPlanar IXM-10 XM - Manual (Page 7)

1352 Charwood Road, Suite D, Hanover, MD 21076 Tel (410) 761-4000 Fax (410) 761-6274
www.polyplanar.com
7
Scan Mode
[2] Presets. Set favorite channels by holding down one
of the Preset buttons (1-6) for 2 seconds.
[3] Tune Up/Down. Use Tune Up and Down to change channels.
[4] Source.
Push “Source” until XM shows as the audio source.
[5] Band. Select preset banks XM1, XM2 and XM3 by pushin
g the “Band”
button. Store up to 6 presets per “Band”
[6] Scan. Scans up through the channels. Stays for 10 seconds and then
increments to the next channel. Push “Scan” again to exit scan mode.
[7] Display.
Push the “Display” button to cycle through “Main, Artist, Song
and Category.
[8] Category.
Push the “Category” button to cycle through the XM content
categories. The first time will display the current category. The display will
show “CA” and each press of the “Category” button will move to the next
category. Category mode will time-out after 15 seconds of idle. To tune to
a station within a category, use the UP/DOWN tuning buttons.
Band Signal Strength Preset #