sE Electronics USB2200a User Manual
Se electronics, Usb2200a – technical information, Technical specifications

USB2200a – Technical Information
Based on the studio standard sE2200a, the USB2200a records via USB directly to your DAW
and has several features unique from competitor USB mics including, zero latency head-
phone monitoring, mix control playback/record path, 10dB pad, bass cut and simultaneous
analogue/USB feeds.
The USB2200a also has a proprietary chip and software set which deals with capsule noise
when transforming the 5v power supplied via the USB cable to power the capsule, by first
removing noise and spikes from the current. This noise would normally be amplified, which
is why other USB mics are too noisy to use in a professional environment.
No other USB mic on the market offers this kind of specification, and it makes a huge
difference to the performance for studio use. The chip also delivers true plug in and play
capability, automatically configuring the mic to the host as it is connected.
Technical Specifications
Acoustical operating principle:
Pressure gradient
transducer
Maximum SPL for THD 0.5%2):
123 dB (cardioid)
Directional pattern:
Cardioid
Maximum SPL for THD 0.5% with
preattenuation2) :
133dB
Frequency range:
20 Hz ... 20 kHz
Maximum output voltage:
1500 mV
Sensitivity at 1 kHz into 1 kohm:
55 mV/Pa1)
Dynamic range of the microphone
amplifier (A-weighted):
109dB
Rated impedance:
50 ohms
Supply voltage (P48, IEC 61938) :
48 V ± 4 V
Rated load impedance:
1 kohms
Current consumption (P48, IEC 61938):
4mA
Equivalent noise level, CCIR1) :
27dB
Matching connectors:
XLR3F
Equivalent noise level, A-weighted1):
14dB-A
Weight:
565g
Signal-to-noise ratio, CCIR1) (rel. 94 dB SPL)
:
69dB
Diameter:
59mm
Signal-to-noise ratio, A-weighted1) (rel. 94 dB SPL):
82dB
Length:
163 mm
1) According to IEC 60268-1; CCIR-weighting acccording to CCIR 468-3, quasi peak; A-weighting according to IEC 61672-1, RMS
2) Measured as equivalent el. input signal
Polar pattern and Frequency Chart
Hypercardioid
Technical Parameters:
1. USB 2.0 USB1.x compatible
2. Stereo D/A and A/D conversion
3. Zero latency Headphone monitoring
4. Gain Control built in
5. At THD > -90db, SNR 96db (D/A conversion)
6. At THD > -90db, SNR 92db (A/D conversion)
7. Adaptive 44.1 to 48KHz sampling frequency
USB Connection via a 5-pin mini B, USB cable
sE Electronics
www.seelectronics.com