Breaching Technologies Ram Breaching Door - Manual (Page 7)

Lock Set
Scenario 1 2 3
1 wood
2 wood wood
3 wood wood wood
4 metal
5 metal metal
6 metal metal metal
7 Reinforced Reinforced Reinforced
After closing the door, the desired type and quantity of BTI pins are inserted into the
sockets as shown below. The pin should insert a distance of approximately ¼” into the
socket when fully seated. Due to stresses and strains imparted upon the door structure
during breaching, slight misalignments will occur over time. Accordingly, the system
has been designed such that the amount of engagement into the socket is not extremely
critical.
Once the door has been breached, the broken pins may not fall out or may partially fall
out. A screw driver, or similar tool may be used (as shown) to remove the spent pins
from the opposite direction of installation.