Zanussi ZRB934FX2 - Manual (Page 54)

Warning! Before carrying out any
operations, remove the plug from the
power socket.
Important! To carry out the following
operations, we suggest that this be made with
another person that will keep a firm hold on the
doors of the appliance during the operations.
D C
E
F
A
B
D
A
B C
A
2
1
• Open the doors.
Unscrew the middle
hinge (B). Remove
the plastic spacer
(A).
• Remove the spacer
(F) and move to the
other side of the
hinge pivot (E).
• Remove the doors.
• Remove the left-
hand cover pin of
the middle hinge
(C,D) and move to
the other side.
• Fit the pin of the
middle hinge (C) in-
to the left-hand hole
of the lower door.
• Unscrew the lower
hinge (A)
• Remove the left-
hand cover pins (D)
and move to the
other side.
• Re-screw the lower
hinge (A) on the op-
posite side.
• Unscrew the lower
hinge pivot (B) and
the spacer (C) and
place them on the
opposite side.
• Remove the plugs
(1)on the upper
side of both doors
and move them to
the other side.
• Re-insert the lower
door on the lower
hinge pivot.
• Insert the middle
hinge into the left
drill of the lower
door.
• Unscrew the upper
hinge pivot and
place it on the op-
posite side.
• Fit the upper door
on the upper door
pivot.
• Re-insert the upper
door on the middle
hinge pivot slightly
tilting both doors.
• Re-screw the mid-
dle hinge . Do not
forget the plastic
spacer .
Do a final check to make sure that:
• All screws are tightened.
• The edges of the doors run parallel to the
side edge of the appliance.
• The magnetic seal adheres to the cabinet.
• The door opens and closes correctly.
If the ambient temperature is cold (i.e. in Win-
ter), the gasket may not fit perfectly to the cabi-
net. In that case, wait for the natural fitting of
the gasket.
In case you do not want to carry out the above
mentioned operations, contact the nearest After
Sales Service Force. The After Sales Service
specialist will carry out the reversibility of the
doors at your cost.
54
www.zanussi.com