Dexter Laundry T-600 (Commercial) - Manual (Page 12)

COIN WASHER CYCLE PARAMETER RANGES
The range of each cycle parameter is shown below:
Cycle Time “ct” 0 to 15 minutes for Prewash, Rinse1 and Rinse2
3 to 15 minutes for Wash and Final Rinse
For the bathes that can, if the time is set to zero, then the
bath will be eliminated from the cycle.
Water Temperature “t” HH – hot, CH – warm, CC – cold
The owner can set the bath default. For the wash bath, the
customer overrides the default for that cycle when the
temperature is selected.
Water Level “L”
LO – low
The owner can change the displayed value, but for a coin
washer only LO will be put into the cycle.
Delay Fill “dF”
The selections are “d” for delay the bath time until water
level is reached or “t” to countdown bath time during the
fill.
Spin Time “S”
0 to 10 minutes for Prewash, Wash, Rinse1 and Rinse2
1 to 10 minutes for Final Spin.
“IS” The owner can change the displayed value, but for a coin
washer only 0 will be put into the cycle.
COIN WASHER DEFAULT CYCLE
The following table shows the complete details for the coin washer default cycle.
Bath Bath Cycle
Time
(min.)
Water
Temp.
Water
Level *
Delay Fill Spin Time
(min.)
IS *
Prewash 0 CC LO t 0 0
Wash 9 CH LO t 0 0
Rinse 1 4 CC LO t 1 0
Rinse 2 0 CC LO t 0 0
Final
Rinse
5 CC LO t 4 0
Note *
These default values are preset and cannot be changed.