Zanussi ZFX405W - Manual (Page 29)

Problem Possible cause Solution
Food placed in the appliance was
too warm Allow food to cool to room tempera-
ture before storing.
Products to be frozen are placed
too closely to each other Place the products in a way so that
cold air could circulate among them
It is too cold inside the
freezer Temperature regulator may be set
incorrectly Set a warmer temperature
The appliance does not
work at all. Plug is not connected to the mains
socket properly Connect the mains plug properly
Power does not reach the appli-
ance Try connecting another electrical de-
vice to the power outlet
The appliance is not switched on Switch on the appliance
There is no voltage in the mains
socket (try to connect another ap-
pliance into it) Call an electrician
Plug is not connected to the mains
socket properly Connect the mains plug properly
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "In-
stallation".
3. If necessary, replace the defective door
gaskets. Contact the Service Center.
Technical data
Dimension
Height 520 mm
Width 525 mm
Depth 587 mm
Rising Time 17 h
Voltage 230 V
Frequency 50 Hz
The technical information are situated in the rat-
ing plate on the internal left side of the appli-
ance and in the energy label.
Installation
Caution! Read the "Safety Information"
carefully for your safety and correct
operation of the appliance before installing the
appliance.
Positioning
This appliance can be installed in a dry, well
ventilated indoor (garage or cellar) also, but for
optimum performance install this appliance at a
location where the ambient temperature corre-
29
www.zanussi.com