3 crane inspection points – R&M Materials Handling WIRE ROPE HOISTS User Manual
Page 9
R&M Materials Handling, Inc.
4501 Gateway Boulevard
Springfield, Ohio 45502
☎
: (937) 328-5100
FAX: (937) 325-5319
9/9
R&M Materials Handling, Inc. reserves the right to alter or amend the above information without notice.
3 Crane inspection points
The inspection instructions that are specific to the hoist should primarily be applied when inspecting the
hoist. The table below lists some general crane inspection points and inspection methods. The inspection
interval for a crane in continuous duty is 1 week. Cranes in intermittent duty should be inspected before
being used. The measurements to be taken at the inspection points are necessary if other methods do
not produce an adequate result. If any defects or abnormalities are observed, they must be investigated
and corrective action must be taken in accordance with the instructions specific to that device.
Inspection method
Structure/
component
Inspection point
Visual
Aural
Test by
hand/
measure
Hoist
See the separate specification for
specific hoist components in the Hoist
Owner’s Manual.
Fastenings of travel machinery units
X
Operation of motors
X
X
X
Operation of brakes
X
X
X
Operation of gears
X
X
X
Oil quantities in gearboxes
X
Condition of rail wheels
X
Bridge travel
machinery
Operation of limit switches
X
X
Fastenings of travel machinery units
X
Operation of motors
X
X
X
Operation of brakes
X
X
X
Operation of gears
X
X
X
Oil quantities in gearboxes
X
Condition of rail wheels
X
Trolley travel
machinery
Operation of limit switches
X
X
Condition of cables
X
Condition of cable trolleys
X
X
Condition and cleanness of cable
support rails
X
Cleanness of equipment and devices
X
Condition of wiring in electrical cubicles
X
X
Condition of cable seals
X
X
Trolley
power supply
Operation of delay relays
X
X
Operation of contactors
X
X
X
Adjustment of over-current protectors
X
X
Condition of fuses
X
Cleanness of starting resistors
X
Fastening of wiring to starting resistors
X
Electrical
cubicles
Operation and condition of main switch
X
X
Cleanness and removal of unnecessary
objects
X
Condition of trolley travel rails
X
Condition of buffers and end stops
X
Steel
structure
Condition and fastening of handrails
X
Condition of crane runway
X
Condition of earthing
X
X
Crane
runway
Condition of crane current collectors
X