KIA Magentis 2007 User Manual

Page 91

Knowing your vehicle

Reprogramming a single
HomeLink® button

To program a new device to a previously
trained HomeLink® button, follow these
steps:
1. Press and hold the desired

HomeLink® button. Do NOT release
until step 4 has been completed.

2. When the indicator light begins to flash

slowly (after 20 seconds), position the
handheld transmitter 1 to 3 inches
(2 to 8 cm) away from the HomeLink®
surface.

3. Press and hold the handheld transmit-

ter button. The HomeLink® indicator
light will flash, first slowly and then rap-
idly.

4. When the indicator light begins to flash

rapidly, release both buttons.

5. Press and hold the just-trained

HomeLink® button and observe the
red Status Indicator LED. If the indica-
tor light stays on constantly, program-
ming is complete and your new device
should activate.

Erasing HomeLink® buttons

Individual buttons cannot be erased.
However, to erase all three programmed
buttons:
1. Press and hold the two outer

HomeLink® buttons until the indicator
light begins to flash-after 20 seconds.

2. Release both buttons. Do not hold for

longer than 30 seconds.

The Integrated HomeLink® Wireless
Control System is now in the training
(learn) mode and can be programmed at
any time following the appropriate steps
in the Programming sections above.

FCC ID: NZLZTVHL3
IC: 4112A-ZTVHL3

This device complies with Industry
Canada standard RSS-210. Operation
is subject to the following two conditions:
(1) this device may not cause harmful
interference, and
(2) this device must accept any interfer-
ence received, including interference that
may cause undesired operation.

NVS® is a registered trademark and Z-
Nav™ is a trademark of the Gentex
Corporation, Zeeland, Michigan.
HomeLink® is a registered trademark
owned by Johnson Controls,
Incorporated, Milwaukee, Wisconsin.

WARNING

The transceiver has been tested
and complies with FCC and
Industry Canada rules. Changes or
modifications not expressly
approved by the party responsible
for compliance could void the
user's authority to operate the
device.