Hotpoint Ariston PFT 834X - Manual (Page 15)

EN
15
Anti-flooding protection
To ensure floods do not occur, the dishwasher:
- is fitted with a special system which blocks the water supply
in the event of malfunctions or leaks from inside the appliance.
Some models are also equipped with the supplementary New
Acqua Stop
*
safety device, which guarantees anti-flooding
protection even in the event of a supply hose rupture.
WARNING: HAZARDOUS VOLTAGE!
Under no circumstances should the water inlet hose be cut as
it contains live electrical parts.
Electrical connection
Before inserting the plug into the electrical socket, make sure
that:
• The socket is earthed and complies with current
regulations.
• The socket can withstand the maximum load of the
appliance, which is indicated on the data plate located on
the inside of the door (see chapter entitled Description of
the appliance).
• The power supply voltage falls within the values indicated
on the data plate on the inside of the door.
• The socket is compatible with the plug of the appliance. If
this is not the case, ask an authorised technician to replace
the plug (see Assistance); do not use extension cables or
multiple sockets.
Once the appliance has been installed, the power supply
cable and the electrical socket should be easily accessible.
The cable should not be bent or compressed.
If the power supply cable is damaged, it must be
replaced by the manufacturer or its Technical Assistance
Service in order to prevent all potential hazards. (See
“Assistance”)
The Company shall not be held responsible for any
incidents that occur if these regulations are not observed.
Anti-condensation strip *
After installing the dishwasher, open the door and stick the
adhesive transparent strip under the wooden shelf in order to
protect it from any condensation which may form.
Advice regarding the first wash cycle
After the appliance has been installed, immediately before
running the first wash cycle, completely fill the salt dispenser
with water and add only then approximately 1 kg of salt (see
chapter entitled Rinse aid and refined salt). The water may
overflow: this is normal and is not a cause for concern. Select
the water hardness value (see chapter entitled Rinse aid and
refined salt). After the salt has been poured into the machine,
the LOW SALT indicator light
*
switches off.
If the salt container is not filled, the water softener and the
heating element may be damaged as a result.
*
Only available in selected models.
Technical data
Dimensions
Width 59.5 cm
Height 82 cm
Depth 57 cm
Capacity 14 standard place-settings
Water supply
pressure 0.05 - 1 MPa (0.5 - 10 bar)
7.25 – 145 psi
Power supply
voltage
See appliance data plate
Total absorbed
power
See appliance data plate
Fuse See appliance data plate
This dishwasher conforms to
the following European
Community Directives:
- 2006/95/EC (Low Voltage)
- 2004/108/EC
(Electromagnetic compatibility)
- 2005/32/EC (Comm. Reg.
1275/2008) (Ecodesign)
- 97/17/CE (Labelling)
- 2002/96/CE (Disposal)