PowerWalker VI 650 IEC - Manual (Page 8)

6. Functions & Operation
I: DC Start Function
DC Start Function enables UPS to be started up when AC utility power is not available and battery is fully
charged. Just simply press the power switch to turn on the UPS.
II: Green Power Function
These series are equipped with Green Power Function for saving power and protecting battery. The feature of
deep discharge protection is adoped on battery mode. If no load is connected to the UPS, it will automatically
shut down after 5 minutes for energy saving while running on battery mode. The UPS will restart while AC
recovery.
III: AVR (Automatic Voltage Regulation)
If the quality of the incoming mains is poor, the AVR boosts a low incoming voltage or reduces a high one. The
load receives a voltage within the normal range.
IV: Auto restart while AC recovery
V: Audio Indicator
Audible Alarm Situation
Sounding every 10 seconds Battery Mode
Sounding every 1 second Battery Low
Sounding every 0.5 seconds Overload
continuous sounding Faulty
7. Software Installation on your PC
Connected by USB to a PC or notebook, the Software enables communication between the UPS and the
computer. The UPS software monitors the status of the UPS, shuts down the system before the UPS is
exhausted and can remotely observe the UPS via the Network (enabling users to manage their system more
effectively). Upon AC failure or UPS battery low, UPS takes all necessary actions without intervention from the
system administrator. In addition to automatic file saving and system shut-down functions, it can also send
warning messages via pager, e-mail etc.
•
Use the bundled CD and follow the on-screen instructions to install the software WinPower.
•
Enter the following serial No. to install software: 511C1-01220-0100-478DF2A
•
After the software is successfully installed, the communication with UPS has been established and a
green icon will appear in the system tray.
•
Double-click the icon to use the monitor software (as above).
•
You can schedule UPS shutdown/start-up and monitor UPS status through PC.
•
Detail instructions please refer to the e-manual in the software.
Check www.powerwalker.com/winpower.html from time to time to get the latest
version of monitoring software.
EN