PowerWalker WinPower Software V.4.3.0.1 Quick Guide - Manual (Page 5)

Function Explanation of “Shutdown Parameter”
1. To support the remote monitor/control function of WinPower, you need to have the similar
connection as above. It means that the Agent is connected to the UPS via RS232/USB and the other
Computers are protected via the AC Power only and all the computers are communicated under the
same Network with LAN.
2. All the computers need to install the WinPower software to keep them with the same interface for
remote shutdown application. If you don’t install the WinPower on them then you would not
able to do the remote monitor/control.
3. Owing to the fact that there is no RS232 cable connect to PC-A ~ PC-C, so you will see the
message of “no connection”. Moreover, you would find that these PC is without the in the
front of the PC listed in the WinPower monitor screen as below.
4. If all the computers are communicated within the “same section of network”, the software will