Dual Electronics XDMA6630 - Manual (Page 6)

6
Faceplate Removal
Semi-Permanent
Faceplate Installation
Power On/Off
Mode
Auxiliary Input
Steering Wheel Interface
Input
Volume
Mute
Reset
Display
Set the Clock
12/24-Hour Clock
General Operation
XDMA6630 OPERATION
Press RELEASE and pull away from the left side to remove.
To re-install, insert right side of faceplate first then push
left side to secure.
Remove trim ring and install supplied #1 x 7/32” Phillips
head screw through left side of mounting frame into faceplate.
Press or any other button (except eject) to turn the unit on.
Inserting a disc will turn the unit on automatically. Press and
hold to turn the unit off.
Press MODE to select between AM/FM, CD player, operation
iPod, USB, auxiliary input and Bluetooth modes. Modes of
operation are indicated in the display.
Note: CD mode will not appear unless a CD is inserted. USB
mode will not appear unless a USB device is connected.
Operation of iPod mode will not appear unless an iPod device
is connected.
Insert 3.5 mm plug to connect your portable audio device.
The steering wheel interface input located on the back of the
head unit allows connection to the PAC (Pacific Accessory
Corporation) SWI-PS interface module (sold separately). Visit
www.pac-audio.com for details.
To configure steering wheel controls, follow the instructions
provided with the PAC SWI-PS interface module. After
installing the interface module, insert the module's 3.5mm
jack into the port on the back of the head unit.
Adjust volume using volume knob (00-46).
Press MUTE to silence the audio. “MUTE” will flash in the
display. Press MUTE again to cancel.
Press to RESET the unit upon initial installation or if
abnormal operation occurs. The reset button is located
behind the faceplate.
Press DISP to select between clock and different types of
information, such as radio frequency, CD track or MP3 CD/
USB song information.
With the unit on, press and hold DISP until the clock begins
to flash, then release. Press TUNE nn to adjust the
hours and TUNE
ll
to adjust the minutes. Press DISP
momentarily to save the selected time.
The clock will display 12-hour AM/PM time in USA frequency
spacing mode (PM 10:00). In European frequency spacing
mode, the clock will display 24-hour time (22:00).