RocketFish RF-RSCWLN12 - Quick Setup Guide - Manual

Thank you for purchasing this high-quality Rocketfish
infrared shutter control for your Nikon DSLR camera.
Your shutter control triggers your camera’s shutter when
using slow shutter speeds. Because you do not touch
your camera when using your shutter control, you
experience less camera vibration and get sharper
pictures. Your shutter control is especially useful for
taking self-portraits.
Package contents
• Remote Wireless Shutter Control
• CR2025 battery
• Lanyard
• Quick Setup Guide
Features
Using your remote control
1 Pull the plastic insulation sheet out of your shutter
control before using it the first time.
2 Set your camera to IR mode. For instructions, see the
documentation that came with your camera.
3 Attach your camera to a tripod, or place it on a steady
surface like a shelf or table.
4 Point your shutter control directly at your camera’s IR
receiver, then press the shutter button on the front of
your shutter control. When your camera receives the
IR signal, it automatically focuses and takes a picture.
Troubleshooting
If your camera does not focus and take pictures:
• Make sure that your shutter control is within
32.8 ft (10 m) of the camera’s IR receiver.
• Make sure that your camera is in IR mode. See your
camera’s user manual to activate the IR mode.
• Make sure that your camera has an autofocus feature.
See your camera’s user manual to activate auto focus
(if available).
• Make sure that the battery for the shutter remote
control is not expired. Replace with a CR2025 battery
if necessary.
• Make sure the line of site between the transmitter
and the infrared receiver is not blocked by the lens or
other obstacles.
Plastic insulation
sheet
Battery holder QUICK SETUP GUIDE
Remote Wireless Shutter Control
for Nikon DSLR Cameras
RF-RSCWLN12
Shutter button
BATT.
RF-RSCWLN12_11-1220_QSG_V1.eps 1 11/28/2011 12:10:40 PM RF-RSCWLN12_11-1220_QSG_V1.eps 1 11/28/2011 12:10:40 PM