Cobalt Digital COMPASS 9005 Triple 3G_HD_SD Reclocking Distribution Amplifier - Manual (Page 10)

Page 10 9005 Owner’s Manual •••• (V 1.3)
Rear Module Installation (Optional)
If you are installing the card into a slot with no rear module, you should have ordered and received a
Rear Module with your card. You will need to install it in your 8321 frame before you can connect
cables.
Use the following steps to install the rear module in an 8321 openGear ® frame:
1. Refer to the 8321 frame Owner’s Manual, to ensure that the frame is properly
installed according to instructions.
2. On the rear of the 8321, locate the card frame slot.
3. As shown in Figure 2, seat the bottom of the rear module in the seating slot at the
base of the frame’s back plane.
Figure 2. Rear Module Installation
4. Align the top hole of the rear module with the screw hole on the top edge of the 8321
back plane.
5. Using a Phillips driver and the supplied screw, fasten the rear module panel to the
8321 back plane. Do not over tighten.
This completes the procedure for installing the rear module in an 8321 frame.