Nemco Food Equipment Fresh-O-Matic - Operations Manual - Manual (Page 4)

NEMCO FOOD EQUIPMENT 301 Meuse Argonne, Hicksville, OH 43526
Phone: (419) 542-7751 Fax: (419) 542-6690 Toll free: 1-800-782-6761
www.nemcofoodequip.com
4
48182
9/26/2012
PROBLEM REASON SOLUTION
No Steam • Air in line
• Power not on
• Water level low
• Unit has cooled by holding the steam button or
unit has been used too often.
• Water level too low.
• Holes have become "plugged"
• Heat unit, press steam button and hold 5-10
seconds (two or three times).
• Turn on power.
• Fill unit with distilled water.
• Allow for reheat - Green Heat Light off.
• Fill unit with distilled water.
• Clean and use perforated tray only.
Green Heat Light
constantly blinks • Unit overused. Heated plate has cooled by holding
the steam button or unit has been used to often.
• Allow unit more time to recover.
NOTE: Light will blink during start-up (20 minutes)
Water Under Unit • Overfilling or tipping the unit.
• Condensation from under the cover. • Do not overfill or tip unit.
• Check hose connections and secure, if
necessary.
Water On Plate
• Pressing steam button to often or holding down the
steam button.
• Allow 30-second between each demand for
steam.
Model Volts Amps Watts Hz Phase
6625A 120 12.5 1500 60 1
TROUBLESHOOTING