Snap-On 5000-3 - Manual (Page 30)

SETUP AND PROGRAMMING CHAPTER 3
To Program AUTO CLEAR, STORE, or SEND:
1. Press (Setup).
2. Scroll Down (
↓) to select Auto settings.
The display reads:
3. Press Enter (
↵). The display reads:
4. Use Right (
→) and Left (←) Cursor to position the reverse-video characters under
the function being changed. To program:
CLEAR, press Up (
↑) or Down (↓) cursor to select "man" (manual clear), "auto"
(automatic), or (delayed automatic) from "1Sec" to "9Sec" seconds.
STORE, press Up (
↑) or Down (↓) cursor to select "man" (manual) or "auto"
(automatic).
SEND, press Up (
↑) or Down (↓) cursor to select "man" (manual) or "auto"
(automatic).
5. Press ENTER (
↵) to save ‘Auto settings’ and to return to measurements mode.
DATA LIST Memory
When changing sensors, or when creating a new statistical data list, the data list memory
must be cleared. The entire memory list or any single memory location may be
selectively cleared. Clearing from the top of the list decrements the total number of
memory locations. Clearing from inside the list shifts all subsequently taken readings
down from that location and decrements the total number of memory locations.
3-7