Grain Systems Bin Accessories PNEG-301 - Manual (Page 5)

1. Installation
PNEG-301 Two-Ring Door 5
4. If some latch bars are loose or require excessive force to lock, loosen hex socket capscrews and
adjust in or out until latch bars operate smoothly. Check that the panels are fully seated over all
bearing pins.
5. Re-install outer cover. Adjust outer door hinges and latches as required.
6. Assemble door hold back as shown on Page 6 . Open door cover until it approaches the bin wall.
Hook retaining bracket over lower latch mount and position the door hold back against bin wall in
a valley. Drill a 3/8" hole through the bin wall and bolt the door hold back to the bin.