Grain Systems Tanks PNEG-4042 - Manual (Page 75)

8. Instructions
PNEG-4042 40 Series 42' and 48' Diameter Bins 75
Wire Grill Guard Roof Vent Assembly and Installation Instructions
The following instructions are for assembling and installing the wire grill guard roof vent. Before beginning
assembly, check the packing list to ensure all components have been received. The unit is easiest
assembled in the upside down position as shown in
Figure 8F . Locate the roof vent as shown in
Figure 8J on Page 77 .
Assembly
1. Turn one roof vent housing (MIS-6778) upside down. (See Figure 8F.)
2. Insert 5/16" x 1-1/4" bin bolt with neoprene washer through the hole in the side of the roof vent.
Place jamb nut onto the bolt and tighten. (See Figure 8F.)
3. Slide one eyelet of grill guard onto the 5/16" bin bolt.
4. Insert 5/16" x 1-1/4" bin bolt with neoprene washer through the other side of the roof vent, through
jamb nut and other eyelet of grill guard. Tighten nut against vent housing side.
5. Apply a bead of tube caulking around the three (3) housing sides of the roof vent where it meets the
hold-down angle.
6. Place hold-down angle (MIS-4404) on the assembled roof vent. The wide end of the hold-down angle
must face the vent discharge. Once aligned, screw nine (9) #10 self-drilling (S-280) screws through
the roof housing and into the hold-down angle.
(See Figure 8G on Page 76.)
Figure 8F
Ref # Part # Description
A MIS-6776 Grill Guard
B MIS-6778 Vent Housing Assembly
C 5/16" x 1-1/4" Nut and Bolt