Grain Systems Bin Accessories PNEG-248 - Manual

Date: 05-29-08 PNEG-248
Instructions
1004 East Illinois Street • Assumption, IL 62510 • 217-226-4421
PNEG-248
Printed in the U.S.A.
Copyright © 2008 by GSI Group
www.gsiag.com
Page 1 of 2
Wire Grill Guard Roof Vent
Wire Grill Guard Roof Vent Assembly and Installation Instructions
The following instructions are for assembling and installing the wire grill guard roof vent. Before beginning
assembly, check the packing list to ensure all components have been received. The unit is easiest
assembled in the upside down position as shown in
Figure 1. Locate the roof vent as shown in Figure 5.
Assembly
1. Turn one (1) roof vent housing (MIS-6778) upside down. (See Figure 1.)
2. Insert 5/16" x 1-1/4" bin bolt with neoprene washer through the hole in the side of the roof vent. Place
jamb nut onto the bolt and tighten. (See Figure 1.)
3. Slide one eyelet of grill guard onto the 5/16" bin bolt.
4. Insert 5/16" x 1-1/4" bin bolt with neoprene washer through the other side of the roof vent, through
jamb nut and other eyelet of grill guard. Tighten nut against vent housing side.
5. Apply a bead of tube caulking around the three (3) housing sides of the roof vent where it meets the
hold down angle.
6. Place hold down angle (MIS-4404) on the assembled roof vent. The wide end of the hold down angle
must face the vent discharge. Once aligned, screw nine (9) #10 self drilling (S-280) screws through
the roof housing and into the hold down angle.
(See Figure 2.)
Figure 1 Figure 2