beautypg.com

Grain Systems Bin Accessories PNEG-1782 User Manual

Instructions, Hopper view window assembly instructions

background image

Date: 11-11-10

Instructions

1004 East Illinois Street • Assumption, IL 62510 • 1-217-226-4421

Page 1 of 1

Printed in the U.S.A.
Copyright © 2010 by GSI Group
www.gsiag.com

PNEG-1782

PNEG-1782

Hopper View Window

Assembly Instructions

Figure 1

1. Using one of the metal facing rings (BLK-10028) as a guide, trace center and bolt hole pattern on

hopper sheet at desired location.

2. With, appropriate tools, remove 4-1/4" center hole from hopper panel. Center punch the eight (8) hole

locations and drill using 3/8" diameter bit.

3. Center plexiglas window (BLK-10030) between facing ring (BLK-10028) and flat gasket

(BLK-10029). Then take components and align and place gasket against exterior surface of
hopper panel.

Align and place second facing ring (BLK-10028) on interior surface of hopper panel.

4. Secure components together with eight (8) bolts (S-275) and nuts (S-396) supplied. DO NOT OVER

TIGHTEN, AS DAMAGE TO PLEXIGLAS WINDOW MAY OCCUR.

(See Figure 1.)

Table of contents