Grain Systems Bin Accessories PNEG-1655 User Manual
Page 16
5. Assembly Instructions
16
PNEG-1655 VTDL-135' - 8' x 9' Door Assembly w/ Manway
15. Assemble outer cover as shown
. Apply strip of caulk behind column and header angles
before attaching them to column and header beam clips. Attach center post and center door latch
(VTDL-0293) to header angle and threshold weldment. Apply caulking to the top and bottom of center
post. Assemble door outer cover, reinforcement channels, hinges, latch brackets and door handles
as shown
. 3/8" x 1" Bin bolts will be used for all connections. Use 3/8" nut and sealing
washer as spacer between latch bracket and outer cover. Place outer cover in door frame and align
hinge weldment (VTDL-0574) with hinge bracket (VTDL-0292). Insert hinge pins (VTDL-0335)
through hinges and hold in place with washers and cotter pins. Review details G-I
for connection details. Adjust door hinges and latches as necessary until door opens and closes
smoothly. Apply foam seal strip around perimeter of outer cover and caulk as necessary to seal
outer cover. Place decals DC-GBC-2A and DC-GBC-2S on the outer cover as shown
.
16. To open door, open outer cover and remove door cover or tie back to bin, remove center post, unbolt
door panels from door frame. Do not remove hinges or unbolt door panels from one another. Swing
door panels open to remove center column. Provisions should be made to hold the door panels open
while center column is being removed and bin is being cleaned. Unbolt top of center column from
header beam and remove shim plate. Slide center column section inside off the threshold weldment,
tilt outward and remove. Caution center column is extremely heavy and proper equipment should be
used for removal. Temporary ramps should be made to avoid driving over the door panel attachment
plates of the threshold weldment. Once the bin is fully emptied, re-install the center column section,
close door panels and bolt panels to door frame. It may be necessary to reseal around door panels
and column weldments. Close outer cover and reseal as necessary. Inspect all decals each time
door is opened and replace if damaged or missing.