Grain Systems Bin Accessories PNEG-1884 - Manual (Page 16)

4. Installation Instructions
16 PNEG-1884 Special 90' Externally Stiffened 2 Ring Door for Use with Enhanced Stiffeners
Inner Door Assembly
The inner door hinges (NCWT0254) are bolted to the inner door frame weldment through tapped holes.
(See detail B in
Figure 4C .) Attach using 3/8" x 5/8" bolts (S-7185) and washer (S-248).
The 2 ring door requires eight (8) total latch bar holders (WD-6234) assembled to the inner door frame
weldment. Washers will be used to adjust the distance between the frame and the latch bar holder for the
best fit of the inner doors. Use 1/2" washers (S-2120) and 1/2" x 1-1/2" bolt (S-3728) to secure the latch
bar holders (WD-6234). (See detail A in
Figure 4C .)
The 2 ring door requires eight (8) total bearing pins (WD-6224) to be used. Attach the bearing pins to the
inner door weldment using 5/16" x 1-1/2" bolts (S-2741), washer (S-845) and flange nut (S-3611). The
bearing pins should be attached at the eight (8) slots in the inner face of the weldment as shown in
Figure 4C . Leave the bearing pins loose until inner doors have been mounted to ensure a better fit.
Tighten the bearing pins once the inner doors are attached.
Figure 4C