Banks Power Toyota Trucks: (Gas ’07 - 14 5.7L Tundra) Exhaust- Monster Exhaust, Single Passenger side exit '07-08 - Manual (Page 6)

Monster Exhaust System Installation
the ground.
CAUTION: DO NOT WORK UNDER
ANY VEHICLE SUPPORTED ONLY
BY A JACK. SEVERE INJURY MAY
RESULT.
3.
From under the vehicle remove the
factory exhaust bolts located on both
flanged Y-Pipes. Keep the removed
bolts. They will be reused in a later
step.
Note: Remove the factory gaskets. The
exhaust system will be hanging by the
hanger clamps.
4.
Liberally apply an aerosol lubricant on
all the hanger pins. Remove the exhaust
system from the vehicle by removing
each hanger pin from the rubber
insulator.
Note: Remove pins from front of vehicle
to rear.
5.
Drop the exhaust system to the floor
and move out of the way. You will not
be reusing any components from the
exhaust system.
6.
Locate the supplied Y-pipe and
Y-pipe ring gaskets from your kit.
Install the Y-Pipe and ring gaskets onto
the flanged fitting on the stock catalyst
converters. Loosely tighten the flange
bolts.
Regular Cab /
Standard Bed Only
7.
If applicable, locate the supplied
2.5 hanger clamps and install onto the
Y-pipe. See Figure 1. Do this for both
pipes on the Y-pipe. Install the pin into
the rubber hanger. Loosely tighten the
hanger clamps.
Note: When installing hanger pins into
rubber insulators make sure that the
pin is pushed properly into place. See
Figure 3.
All Others Models
8.
If applicable, locate the supplied
intermediate pipe and cut the
intermediate pipe based on the
following configurations. See Table 1.
cut the NON-swedged end of the
intermediate pipe. See Figure 2.
Note: Banks Intermediate pipe not
applicable to Regular Cab / Standard
Bed.
9.
Locate and install the intermediate
pipe swedged end onto the Banks
Y-pipe. Install a 3” saddle clamp onto
the swedged end and loosely tighten.
Slide on the sliding hanger clamp
onto the intermediate pipe such that
the hanger pins face the rear of the
vehicle. Install the clamp hanger pins
into the corresponding vehicle rubber
insulators and loosely tighten the
clamp. See Figure 3.
10.
Install the 3” exhaust clamp onto
the inlet of the Banks Monster Muffler
(Note: the inlet labeling of the muffler).
Orient the “Monster” logo such that
it is parallel with the frame rail. Install
the Banks Muffler inlet onto the
intermediate pipe and lightly tighten
the 3” clamp (see Figure 1).
NOTE: All clamps should be positioned
at the beginning of the slots (on the 1⁄2
circle punch) and evenly tightened. See
Figure 4.
11.
Install the 3” hanger clamp onto
the Banks Muffler outlet such that
the hanger pin is facing forward.
Install the clamp hanger pin into
the corresponding vehicle rubber
insulators. See Figure 3.
12.
From the vehicle rear, route
the tailpipe over the rear end. Start
the tailpipe hanger pin into the
corresponding vehicle rubber hanger.
Install the tailpipe into the Banks
Muffler outlet. Lightly tighten the rear
muffler hanger clamp to secure the
tailpipe.
6
97230 v.4.0