Banks Power Nissan Trucks: (Gas ’04 - 11 5.6L Titan) Exhaust- Monster Exhaust, Single Passenger side exit '04-09 - Manual (Page 9)

97058 v.7.0
9
14.
Align the hanger plate assembly
onto the original location of the hanger
such that the rubber hanger is below
the plate and rear of the original
location. Loosely reinstall the two (2)
factory bolts through hanger plate into
the vehicle frame.
15.
Install the factory rubber hanger
onto the rear tailpipe hanger pin.
Reinstall the two (2) M8x1.25 bolts
through the rubber hanger into the
vehicle frame.
16.
Keep the wrapping on the tailpipe
tip until installation is complete.
Adjust the tip about 3⁄4” under the
body panel, inline with the vehicle
body, such that the position is
aesthetically pleasing.
17.
With the exhaust positioned
properly, begin to tighten the clamps
and hardware starting with the ones
closest to the front of the vehicle and
working your way back. Torque the
exhaust clamps evenly to 35 ft-lbs.
Make sure that each slip is fully
inserted (+/- 1 ⁄
2
”). Torque the factory
M8 hardware to 22 ft-lbs. Torque the
5 ⁄
16
” hardware to 19 ft-lbs.
18.
Install the supplied heatshield
blanket onto the y-pipe and left head
pipe connection. Wrap the heatshield
around the clamp and pipes to protect
your transfer case or gas tank (if
applicable). Secure wrapping with the
three (3) tie wraps (see Figure 3).
19.
Remove the protective covering
from the tailpipe tip.
CauTIoN: the protective covering
may ignite and burn if not removed
prior to running the engine.
20.
your system includes two (2)
“Banks Power” logos designed to
complement the Nissan emblems on
the vehicles front fenders (see Figures
5 and 6).
Figure 4B- 2009 Models (Small Plate)