Banks Power Cummins Motorhomes: (Diesel ’98 - 03 ISC 8.3L) PowerPack TLC & Stinger TLC systems '98-03 8.3L, 315, 330 or 350-hp, 24-valve, Class-A MH, Except Common Rail - Manual (Page 2)

Preparation and Precautions
Dear Customer,
If you have any
questions concerning
the installation of
your Banks Power
system, please call
our Technical Service
Hotline at
(888) 839-2700
between 7:00 am and
5:00 pm (PT). If you
have any questions
relating to shipping or
billing, please contact
our Customer Service
Department at
(888) 839-5600.
Thank you.
1.
For ease of installation of your
Banks system, familiarize yourself
with the procedure by reading the
entire manual before starting work.
This instruction manual contains
12
pages of text, illustrations and parts
listing.
2.
Disconnect the ground cable from
the battery before beginning work.
If there are two batteries, disconnect
both.
3.
Route and tie wires and hoses
a minimum of 6 inches away from
exhaust heat, moving parts and sharp
edges. clearance of 8 inches or more
is recommended where possible.
4.
During installation, keep your
work area and components clean
to avoid possible dirt entry into the
engine.
tYPiCAL tOOLs reQUireD:
• Pocket knife or X-Acto knife
• Metric wrench or socket and
ratchet set including 10mm, 13mm
and 15mm
• 5 ⁄
16
”, 7 ⁄
16
” deep 1 ⁄
4
” drive sockets
• 1 ⁄
2
” standard 1 ⁄
4
” drive socket
• Long 1 ⁄
4
” drive extension
• 1 ⁄
4
” ratchet
• (2) 1 ⁄
2
” open end wrenches
• Inch-pound and foot-pound torque
wrenches (suggested)
• Standard and Phillips-head
screwdrivers
• Dead blow hammer
• Needle-nose pliers
• Standard pliers
• Rust penetrant (optional)
• Test light or multimeter
• Clean rags or shop towels
• Standard set of open-end wrenches
• Pry-bar or large water pump pliers
•
9 ⁄
16
” socket and ratchet or wrench
• Wire crimper/ stripper
• Drill motor
•
3 ⁄
16
” and 7 ⁄
16
” drill bits
• 1 ⁄
4
” NPT tap and tap handle
• Heat gun or cigarette lighter
(suggested)
2 |
9 6 4 1 9 v . 4 . 0