Banks Power Dodge Trucks: (Diesel ’03 - 07 5.9L Cummins) Intake- Banks Ram-Air Intake system '03-07 235, 250, 305 and 325 HP, Dodge Cummins 5.9L (24-valve) Trucks - Manual (Page 10)

If installing the Banks Super Scoop
then proceed to steps 8 thru 11.
Otherwise, Skip to Step 12.
For Super Scoop
Installation only
8.
Locate the Banks air housing.
Using a ruler, measure one inch up
from the bottom of the housing and
repeat several times on all sides of the
housing.
9.
Make a line that traces the marks
you have made around the box (see
Figure 6).
10.
Use your Hack Saw to cut along
the line you have made in Step 9 (see
Figure 7).
Note: Cut housing as straight as possible,
it will ease the deburr process.
11.
After you have cut off the
unneeded portion of the housing,
deburr the bottom of the housing to
smooth it out and to prevent debris
from entering the system.
12.
Locate the Banks air housing and
Banks air housing bracket in your kit.
Hand tighten the air housing bracket
to air housing using supplied bolt and
washer. See Figure 8.
13.
Remove the steel insert and
rubber grommet from the factory air
housing. See Figure 9.
14.
Insert the rubber grommet flange
side down into the air housing bracket.
15.
Press in the steel insert and make
flush to rubber grommet.
16.
Install the Banks air filter housing.
Align the radiator core support bolt
to the air housing bracket hole. Align
the air filter housing holes to threaded
Well-Nuts installed in fender bracket.
See Figure 10.
Note: The compressor supply and
return lines may need to be slightly
bent away from Banks air housing
Figure 5
10
96489 v.5.0