Banks Power Chevy_GMC Trucks: Duramax LLY-LBZ (Diesel ’06 - 07 6.6L) Speed Control- SpeedBrake '06-07 (PDA) For use with PowerPDA User Manual

Page 16

97227 v.7.0

Section 2

MoUNTING THE DoCkING STaTIoN aND

CoNNECTING THE BaNkS PoWERPDa

Figure 14

NoTE: This system has been

designed for use with the Palm

Tungsten E2 PDA.
WaRNING: The PDa may be

susceptible to damage as a result

of extended exposure to sunlight,

heat or extreme cold. It is highly

recommended that the PDa

be removed from its mounting

location if the vehicle will be

subjected to high concentrations

of sunlight, heat or cold for

an extended period of time.

Gale Banks Engineering is not

responsible for damage to PDas

resulting from exposure conditions.
CaUTIoN: Do not use force

when working on plastic parts.

Permanent damage to the part

might result.

Locate the universal mount and

docking station in your kit. Interlock

the docking station to the universal

mount by inserting and sliding the

universal mount tabs into the docking

station grooves. See figure 14.

Find a smooth, flat surface suitable

for ease of access and viewing of

the PowerPDA. See figure 15 for an

example. Loosen both knobs and move

the swivel suction plate and docking

station to achieve desired viewing

angle of the PowerPDA screen. Do a

test fit and note the angle necessary

to achieve the correct viewing angle.

Tighten both knobs to lock in the

position (figure 14).
Note: If the universal mount swivel

does not move or is tight after

loosening the hold down knob, then

remove the previously inserted

docking station and slightly loosen the

tension screw. See Figure 16.

With the alcohol swab from your

kit, clean the suction cup and the

mounting area and let dry. With the

suction lever in the up position ensure

the suction cup is flat against the

windshield or smooth, flat surface.

Then, push the suction lever down to

secure in place