Banks Power Jeep Trucks: (Gas ’12 - 14 3.6L) Exhaust- Monster Exhaust, Single out the back 2012 3.6L Wrangler 2-door User Manual

Page 5

96501 v.1.0

NOTE: Begin cutting just where the

tubing begins to bend at the top. Try

to leave as much straight tailpipe to

receive Banks Front tailpipe.
Using a reciprocating saw, cut the

factory tailpipe. Take time when

measuring and cutting the factory

tailpipe to ensure the proper location

and a straight cut. Improper cut will

result in poor fitment of the Banks

Monster Exhaust system.
NOTE: Gale Banks Engineering has

tested and designed this Monster

Exhaust System to work with the

factory resonator. Keeping the

factory straight-through resonator

design on the vehicle will not

reduce performance and it will help

reduce resonance in-cab due to the

aggressive camshaft profiles and

variable valve timing of the engine

design.

Place a 2.5” saddle clamp on the

inlet of Banks Front tailpipe. From the

vehicle rear, route the Front tailpipe

over the rear end. Install the Front

tailpipe onto the factory tailpipe

outlet. Insert Banks hanger pin into

the vehicle’s rubber hanger. Loosely

tighten the 2.5” clamp.
NOTE: All clamps should be positioned

at the beginning of the slots (on the

⁄

circle punch).
NOTE: Once the pipe / muffler has

been completely engaged in the slip

joint, mark the pipe with a scribe or

tape for reference when tightening the

clamps later in the installation. Mark

each slip joint in this fashion.

Figure 3

See also other documents in the category Banks Power For the car: