Banks Power Dodge Trucks: (Diesel ’03 - 07 5.9L Cummins) Speed Control- Banks Brake with CBC-SmartLock '04-07 - Manual (Page 37)

97055 v.8.0
37
3.
Remove the cluster bezel by first
removing the two (2) screws at the
top. Gently pull on it and disengage
all the clips that attach the bezel
to the dash. Retain the screws for
reinstallation.
4.
Cut out the supplied template
(Figure 48) and align the template
onto the front of the cluster bezel by
placing its left edge against the cluster
rib, and it’s bottom edge against the
cluster bottom edge. Use masking
tape to securely hold down the
template.
Note: Do not tape over the markings
on the template.
It may be necessary to trim some of
the cluster’s ribs for the Switch to fit.
Skip to Step 11.
Location # 2
5.
Remove the dash side panel
(Figure 42). Remove the 2 screws
inside.
6.
Remove the 2 screws at the
bottom of the center knee panel. Pull
at the top to disengage the clips that
hold the knee panel.
7.
Pull at top of the left brake panel
to disengage it’s clips. If applicable,
disconnect any switch wires. Remove
the panel from the truck.
8.
Cut out the supplied template
(Figure 49) and align the template
onto the rear of the brake panel by
placing it’s upper edge against the
upper edge of the panel. Refer to
(Figure 43). Use masking tape to
securely hold down the template.
Note: Do not tape over the markings
on the template.
Skip to Step 11.
Figure 41 Location #2- Late 2004 thru 2005 models