Banks Power Ford Trucks: (Diesel ’08 - 10 6.4L Power Stroke) Exhaust- Monster Exhaust, Single Passenger side exit '08-10 F-250_ F-350 - Manual (Page 10)

10
96534 v.4.0
10.
Route the Front Tailpipe over the
rear axle housing and install the Front
Tailpipe onto the Banks Intermediate
pipe outlet. Loosely snug the rear
hanger clamp.
11.
Install the 4” exhaust clamp onto
the inlet of the Rear Tailpipe. Start
the Rear tailpipe hanger pin into the
corresponding vehicle rubber hanger.
Position the rubber hanger as shown
in Figure 3. Install the Rear Tailpipe
over the outlet of the Front Tailpipe.
Slide the 4” clamp into position that
best supports the tailpipe assembly.
Loosely snug the hanger clamp on the
intermediate pipe outlet.
12.
Adjust the Tailpipe Tip under the
rear fender such that the tip position is
aesthetically pleasing.
CAUTION: IF THE TAILPIPE IS
IN CONTACT WITH THE REAR
UNDERCARRIAGE FENDER LINING,
USE TEMPLATE 1 TO TRIM THE
LINING AS SHOWN IN FIGURE 4.
13.
With everything positioned
properly, begin to tighten the clamps
starting with the ones closest to the
turbo and working your way back.
Evenly torque the exhaust clamps to
35 ft-lbs. Make sure that each slip is
fully inserted (+/- 1⁄4 inch).
14.
Remove the protective covering
from the tailpipe tip.
CAUTION: THE PROTECTIVE
COVERING MAY IGNITE AND
BURN IF NOT REMOVED PRIOR TO
RUNNING THE ENGINE.
15.
Your system includes two “Banks
Power” logos designed to complement
the Ford badging on your truck. Use the
provided measurements (see Figure 5)
to position the logos for a clean factory
look.
16.
Re-connect battery terminals if
previously removed. Banks Monster
Exhaust installation is now complete.
Figure 4 Placement of template on Passenger side rear undercarriage lining.