Banks Power Ford Trucks: (Diesel ’03 - 07 6.0L Power Stroke) Intake- Ram-Air Intake system '03-07 F-250-350-450 pickup - Manual (Page 13)

19.
Using the supplied large washer
and bolt install and tighten the
radiator/intercooler fastener. See
Figure 9.
20.
Locate the Banks air filter housing
and drop in and insert the inlet then fit
the air housing feet into place on the
factory grommets. See Figure 10.
21.
Feed the rear Banks intake tube
through the opening of the Banks air
filter housing and fasten into position
using the supplied screws. See Figure
11 and Figure 12.
22.
Insert the intake tube into the
factory bellows and tighten the hose
clamp.
23.
connect the MAF/IAT connector
to the MAF/IAT sensor.
24.
Insert the air filter Minder into the
intake tube. See Figure 13.
25.
Place air filter hose clamp on air
filter. Do not tighten the clamp.
26.
Drop in Banks air filter with hose
clamp and fit air filter lip onto intake
tube securing that the air filter is
inserted properly. Using hand tools
tighten the air filter hose clamp. See
Figure 14.
Warning: Filter may come loose
at connection point due to oil
residue. Clean the air filter
connection points with a non-oil
based solvent such as Acetone,
Mineral Spirits, Denatured
Alcohol, or Lacquer Thinner. Read
and follow the manufactures
operation instruction for non-oil
based solvent cleaner. Be careful
not to apply cleaner to cotton
filter media or damage to media
may result.
Figure 10
96463 v.7.0
13