VANCO VPW-280794 - Manual (Page 5)

www.vanco1.com
888.769.4156 5
CONNECT AND OPERATE
1. Connect up to 4 sources such as a Blu-Ray Player, game console, A/V Receiver, Cable or Satellite
Receiver, etc. to the HDMI inputs on the unit. Do not hotplug! Insert and extract cables carefully with the
power SWITCHED OFF. Connecting and disconnecting while the unit is powered can result in damage to
circuitry.
2. Connect the output UTP ports and/or HDMI output ports, starting with output 1, to the included display
receivers (using well terminated or pre-terminated Cat5e/6 cables no longer than 131 ft)
3. If utilizing UTP, connect the output HDMI ports of the display receivers to high-definition displays such as
an HDTV or HD projector that use HDMI inputs. Note that high-speed HDMI cables are recommended for
the distances that are required for each connection.
4. Plug in IR transmitters to the back of the Matrix Selector Switcher unit (IR TX), the transmitters are
labeled IR TX, place in front of the IR receiver of the source, ensure that each emitter is placed in front of
the IR receiver eye. Double-sided adhesive tape provided.
5. Plug in IR receivers to the port of the display receiver baluns (IR RX), the receivers are labeled IR RX, use
provided double-sided adhesive tape to stick emitters at each display at a desired place that will receive a
remote signal.
6. For power, plug in the source first, followed by the Vanco Powered by Wyrestorm Matrix Selector
Switcher (power supply included), followed by each output connected.
7. Power on each device in the same sequence.
At this point each display connected should display the assigned source (input 1 at default when powered
on initially), scroll through each of the sources on each display to ensure everything is in working order. Use
included IR remote at each display receiver to test switching function between sources and IR function itself.
If a display is having difficulty receiving a signal, access the display’s menu and adjust the resolution (lowest to
highest until signal is displayed). A 24 Hz vertical refresh rate may work better than 60 Hz or higher. If the IR
remote function is not responding, check the emitters to ensure they are placed correctly and are plugged into
the correct IR jacks on the Matrix Selector Switcher unit.
Game
Console
Apple TV
Cable Box BluRay® Player