VANCO VPW-280782 (1x2) - Manual (Page 7)

www.vanco1.com
888.769.4156 7
CONNECT AND OPERATE
1. Connect a single source such as a Blu-Ray Player, game console, A/V Receiver, Cable or Satellite Receiver,
etc. to the HDMI input on the unit.
2. Connect the splitter output HDMI ports, starting with port 1, to high-definition displays such as an HDTV
or HD projector that use HDMI inputs. Note that high-speed HDMI cables are recommended for the
distances that are required for each connection.
3. For power, plug in the source first, followed by the Vanco Powered by Wyrestorm Splitter (power supply
included), followed by each output connected.
4. Power on each device in the same sequence.
At this point each display connected should display identical and synchronized picture and sound from the
source. If a display is having difficulty receiving a signal, access the display’s menu and adjust the resolution
(lowest to highest until signal is displayed). A 24 Hz vertical refresh rate may work better than 60 Hz or
higher.