VANCO VPW-280772 (4X2) - Manual (Page 5)

www.vanco1.com
888.769.4156 5
CONNECT AND OPERATE
1. Connect up to 4 sources such as a Blu-Ray Player, game console, A/V Receiver, Cable or Satellite
Receiver, etc. to the HDMI inputs on the unit.
2. Connect the output HDMI ports, starting with ouput 1, to high-definition displays such as an HDTV or HD
projector that use HDMI inputs. Note that high-speed HDMI cables are recommended for the distances
that are required for each connection.
3. Plug in IR receivers to the back of the Matrix Selector Switcher unit (IR RX), the receivers are labeled
IR RX (larger oval shaped emitters), place emitters at each display at a desired place that will receive a
remote signal. Double-sided adhesive tape provided.
4. Plug in IR transmitters to the front of the Matrix Selector Switcher unit (IR TX), the transmitters are
labeled IR TX (smaller, and rounded at the end emitters), use provided double-sided adhesive tape to
stick emitter in front of the IR receiver of the source, ensure that each emitter is placed in front of the IR
receiver eye.
5. For power, plug in the source first, followed by the Vanco Powered by Wyrestorm Matrix Selector
Switcher (power supply included), followed by each output connected.
6. Power on each device in the same sequence.
At this point each display connected should display the assigned source (input 1 at default when powered
on initially), scroll through each of the sources on each display to ensure everything is in working order. Use
included IR remote at each display receiver to test switching function between sources and IR function itself.
If a display is having difficulty receiving a signal, access the display’s menu and adjust the resolution (lowest to
highest until signal is displayed). A 24 Hz vertical refresh rate may work better than 60 Hz or higher. If the IR
remote function is not responding, check the emitters to ensure they are placed correctly and are plugged into
the correct IR jacks on the Matrix Selector Switcher unit.