DeLOCK 89004 - Manual (Page 4)

-4-
Install parallel interface
6. The hardware assistant appears with a newly found parallel interface.
Choose "No, not this time" and click "Continue".
7. Choose "Install software automatically" and click "Continue".
8. Click "Continue installation".
9. Click "Finish".
Install serial interface
10. The hardware assistant appears with a newly found serial interface.
Choose "No, not this time" and click "Continue".
11. Choose "Install software automatically" and click "Continue".
12. Click "Continue installation".
13. Click "Finish".
14. When the second serial port is found, repeat steps 1 – 4.
Your PCI card is installed and ready for use.
Windows 2000/XP Service Pack 1
Controller installation
1. After installing the hardware and starting your computer the hardware
assistant appears.
2. Put the driver CD in the CD-ROM drive, choose the driver "nm9835s"
and click "Continue".
3. When driver is located, click "Continue installation".
4. Click "Finish".
Install parallel interface
5. The hardware assistant appears with a newly found parallel interface.
Choose "Install software automatically" and click "Continue".
6. Click "Continue installation".
7. Click "Finish".