DeLOCK 89050 - Manual (Page 3)

-3-
Hardware Installation
Note:
Follow the general instructions for installation of the card. If necessary,
read the manual of your computer, or ask a specialist for help.
1. Turn off your PC, and unplug the power cord.
2. Open the housing.
3. Remove the slot holder from the available PCI slot.
4. Insert the card straight and carefully into the free PCI slot, until it is well
seated.
5. Use a screw to attach the card to the housing.
6. Reattach the housing, and connect the power cord to the AC adapter.
DV camcorders require DV device drivers. Usually, they are detected and
configured by the video processing program (Ulead Video Studio) during
installation of the software.
Special drivers are not required for the camcorder. Please refer to the
camcorder's user's guide for further procedures.
Driver Installation
Windows 2000/XP
Restart the computer under Windows after installation of the hardware.
Windows will detect the card and automatically set up the drivers.
Afterwards, the USB 2.0 + FireWire card and its properties are displayed
under Control Panel / System / Device Manager.
Windows 98/98SE/ME
1. After installation of the device, and after start of Windows the message
"New hardware found" appears.
2. In the Hardware wizard click on "Next".
3. Insert the driver CD into the drive and select "Automatically search for
driver", and click on "Next".