Velleman CTC1000KP - Manual (Page 9)

CTC1000KP
V. 01 – 12/06/2013 9 ©Velleman nv
Red LED flashes 5 times, a long beep sounds.
Home Mode
Press .
Red LED flashes 5 times, keypad sounds 3
beeps.
Disarm Mode
Enter a control panel user code and .
Red LED flashes 5 times, keypad sounds 2
beeps.
Enter Test Mode Enter keypad PIN code and press ＊ key.
Green LED lights on, keypad sounds 1 long
beep.
Panic Alarm Press 1 + 3 simultaneously.
Red LED flashes 5 times, a long beep sounds.
Fire Alarm Press 4 + 6 simultaneously.
Red LED flashes 5 times, a long beep sounds.
Medical Alarm Press 7 + 9 simultaneously.
Red LED flashes 5 times, a long beep sounds.
11. Test mode
You can use the test mode to avoid tamper alarm when installing,
replacing low batteries or moving the keypad to a different location.
To put the keypad in test mode:
 Enter the PIN code (default: 0000) followed by ＊.
The green LED will flash, a long beep sounds.
 To exit test mode, press twice.
The keypad will sound a long beep and the green LED will remain
lit.
Test mode: key combinations
In test mode, you can use the following key combinations:
Change the PIN code
Press ＊ and then 6.
Enter old pin code and press .
Enter new 4-digit pin code and
press #.