Velleman CAMCOLD12N User Manual

Page 3

CAMCOLD12N

08.02.2010

©Velleman

4. Installation

• Turn the plastic dome cover counter clockwise and remove it.

• Use the base to determine the location of the mounting holes and hole for

the video/power cable.

• Screw the base in place using 4 screws and connect the

video/power cable. There’s only one way to fit the
connector, do not force.

• Connect the video [1] and power cable [2].

• Aim the camera and close the dome. Align the

protrusions and notches, insert and rotate the plastic
cover ±60° clockwise. Make sure the camera has a clear

view.

5. Technical specifications

pick-up element

1/3" CCD

pixels

753(H) x 582(V) -PAL-

horizontal resolution

500 TV lines

min. illumination

0.1 lux / F2.0

S/N ratio

> 48dB (AGC off)

electronic shutter

1/60 (1/50) to 1/100000s

lens f3.6mm

F2.0

lens angle

79°

iris mode

AES

gain control

auto

white balance

ATW

video output

1Vpp @ 75 ohms

power supply

12VDC / 110mA (use PS1205R, not incl.)

dimensions

Ø100 x 60mm

weight 130g

Use this device with original accessories only. Velleman nv cannot

be held responsible in the event of damage or injury resulted from
(incorrect) use of this device. For more info concerning this product,
please visit our website www.velleman.eu. The information in this

This manual is copyrighted. The copyright to this manual is owned
by Velleman nv. All worldwide rights reserved. No part of this manual may
be copied, reproduced, translated or reduced to any electronic medium or
otherwise without the prior written consent of the copyright holder.