User manual, Introduction, Battery – Velleman SCAMD User Manual
Page 2: Mounting the camera

SCAMD
V. 02 – 26/02/2013
2
©Velleman nv
USER MANUAL
1. Introduction
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of
the device after its lifecycle could harm the environment. Do not
dispose of the unit (or batteries) as unsorted municipal waste; it
should be taken to a specialized company for recycling. This device
should be returned to your distributor or to a local recycling
service. Respect the local environmental rules.
If in doubt, contact your local waste disposal authorities.
Thank you for choosing Perel! Please read the manual thoroughly before
bringing this device into service. If the device was damaged in transit, don't
install or use it and contact your dealer.
2. Battery
1.
Remove the screw at the top of the housing.
2.
Insert three AA batteries of 1.5 V (not incl.) and close the battery
compartment.
3.
The LED starts to flash when the ON/OFF selector (placed on the
bottom of the camera) is placed in the ON position.
4.
The camera pans when the motion sensor detects movement and can
also be tilted manually.
3. Mounting the Camera
1.
Select a mounting location.
2.
Fix the camera to the ceiling with two screws.
Use this device with original accessories only. Velleman nv cannot
be held responsible in the event of damage or injury resulting from
(incorrect) use of this device.
For more info concerning this product and the latest version of this
manual, please visit our website www.perel.eu.
The information in this manual is subject to change without prior
notice.
© COPYRIGHT NOTICE
The copyright to this manual is owned by Velleman nv. All
worldwide rights reserved. No part of this manual may be copied,
reproduced, translated or reduced to any electronic medium or otherwise
without the prior written consent of the copyright holder.