Velleman VTHD06 - Manual (Page 3)

VTHD06 VELLEMAN 3
3. Description
1. chuck
2. lock button
3. speed regulator
4. on/off switch
4. Attaching an Accessory to the Drill
Always disconnect the electric drill from the mains prior to attaching/changing an accessory. Never press the lock
button when the electric drill is operating.
Rotate the chuck to the right and simultaneously press the lock button to loosen. Insert the accessory, press the lock button
and rotate the chuck to the left to tighten.
5. Operation
Select the proper accessory for the proper job. Press the on/off switch and choose the rotation speed. We recommend a
lower setting when working with plastics or for polishing. Depending on the job, hold the electric drill like a pen (drilling,
engraving…) or like a hammer (milling). Always switch off the electric drill after use.
6. Maintenance
• Unplug the electric drill from the mains. Let the electric cool down if necessary.
• Clean the electric drill and all its moving parts using a soft damp cloth and some mild soap if necessary. Never submerge
the drill or use aggressive detergents, alcohol, petrol, etc.
• Keep the air vents unobstructed. Avoid shavings going inside the housing.
• Contact your dealer for spare parts or for servicing the electric drill.
7. Technical Specifications
Power Supply 230VAC/50Hz
Power Consumption 15W
Rotation Speed 8,000 ~ 18,000 RPM with speed adjustment
Use this device with original accessories only. Velleman nv cannot be held responsible in the event of damage or
injury resulted from (incorrect) use of this device.
For more info concerning this product, please visit our website www.velleman.eu.
The information in this manual is subject to change without prior notice.