Installation, Overview, Operation – Velleman VDSABS8A User Manual
Page 4: Cleaning and maintenance, Technical specifications
VDSABS8A
V. 03 – 13/05/2013
4
©Velleman nv
Only use the device for its intended purpose. All other uses may lead to short circuits, burns, electroshocks,
crash, etc. Using the device in an unauthorised way will void the warranty.
4.
Installation
Install the device in a location where few people pass by and that is unreachable for unauthorised persons.
Make sure there is no flammable material within a 50cm radius of the device.
5.
Overview
Refer to the illustrations on page 2 of this manual.
1
Power button “1” on and “0” off
2
Power input jack
3
Low tone level control, 12dB raising attenuation at 100Hz
4
Hi tone level control, 12dB raising attenuation at 3.5 KHz
5
Volume control of RCA line input
6
Volume control of MIC input
7
Microphone ¼” input jacks, can receive unbalance signals
8
RCA (R.L) input jack, can receive both balance and unbalance signals
9
Line output ¼” jack
10
Input signal overload indicator
6.
Operation
Refer to the illustrations on page 2 of this manual.
Make sure the power switch is set to “OFF”.
Set the power switch to “ON”. The device starts operating.
Set the power switch to “OFF” to stop the device.
7.
Cleaning and maintenance
All screws should be tightened and free of corrosion.
The housing, visible parts, mounting supports and the installation location (e.g. ceiling, suspension,
trussing) should not be deformed, modified or tampered with e.g. do not drill extra holes in mounting
supports, do not change the location of the connections.
The electric power supply cables must not show any damage. Have a qualified technician maintain the
device.
Disconnect the device from the mains prior to maintenance activities.
Wipe the device regularly with a moist, lint-free cloth. Do not use alcohol or solvents.
There are no user-serviceable parts.
Contact your dealer for spare parts if necessary.
8.
Technical Specifications
power supply
115/230Vac 50/60Hz
power consumption
max. 150W
woofer size
8” (20.6cm)
tweeter size
1” (2.5cm)
amplifier
100W (80Wrms)
frequency response
45Hz-18kHz
sensitivity (1w/1m)
96dB
impedance
8 Ohm
dimensions
460 x 310 x 270mm
total weight
9kg
inputs
Line 1 MIC: 6.35mm jack /
Line 2: 2 x RCA
output
6.35mm jack