Velleman VDL1200SM2 - Manual (Page 3)

VDL1200SM2
V. 02 – 01/06/2012 3 ©Velleman nv
• Use the original packaging if the device is to be transported.
• All modifications of the device are forbidden for safety reasons.
• Only use the device for its intended purpose. All other uses may lead to short circuits, burns,
electroshocks, crash, etc. Using the device in an unauthorised way will void the warranty.
4. Overview
1 ON/OFF button
2 liquid level gauge
3 wire controller connector
4 power cord
5. Mounting the Device
• Have the device installed by a qualified person, respecting EN 60598-2-17 and all other applicable
norms.
• The carrying construction must be able to support 10 times the weight of the device for 1 hour
without deforming.
• The installation must always be secured with a secondary attachment e.g. a safety cable.
• Never stand directly below the device when it is being mounted, removed or serviced. Have a
qualified technician check the device once a year and once before you bring it into service.
• Install the device in a location with few passers-by that is inaccessible to unauthorised persons.
• Overhead mounting requires extensive experience: calculating workload limits, determining the
installation material to be used… Have the material and the device itself checked regularly. Do not
attempt to install the device yourself if you lack these qualifications as improper installation may
result in injuries.
• Adjust the desired inclination angle via the mounting bracket and tighten the bracket screws.
• Make sure there is no flammable material within a 0.5 m radius of the device.
• Have a qualified electrician carry out the electric connection.
• Connect the device to the mains with the power plug. Do not connect it to a dimming pack.
• The installation has to be approved by an expert before the device is taken into service.
6. Use
Warning: Make sure that the tank never runs empty during operation. If it does run empty, immediately
switch off the fog machine via the power switch and allow it to cool down. You can check the liquid level
on the back of the device (see Overview above).
1. Make sure the power switch is set to OFF.
2. Use the appropriate liquid (see Technical Specifications) to add in the
tank on top of the unit.
3. Insert the power cable into the mentioned power supply.
4. Set the power switch on the backside of the device to ON. The device starts
operating.
5. The green LED on the controller will light up.
6. Push the red button on the controller and the device will start spurting
smoke.
7. Set the power switch to OFF to stop the device.