Velleman WC3320 - Manual (Page 6)

WC3320 Rev. 02
02/12/2009 ©Velleman ® nv 6
• Use the up [I] and/or down [J] button to set the desired lower temperature limit. Press and
hold the buttons will increase setting speed.
• When multiple sensors (channels) are used, press the channel button [F] to move to the next
channel and set its desired lower temperature limit.
• Press the alarm button [H] again to store the setting and return to normal mode.
• Press the alarm button [H] shortly to switch the alarm on or off; when the alarm indicator [M]
is shown, the alarm is enabled.
• When the set upper or lower limit is reached, the clock will generate an alarm sound and the
temperature indication starts flashing. Press the alarm button [H] to switch off the alarm.
Note: the alarm will switch on or off for all channels simultaneously.
9. Maintenance
• Wipe the clock and sensor regularly with a moist, lint-free cloth. Do not use alcohol or solvents.
10. Batteries
Clock
• Insert a new 1.5V AA battery in the battery compartment in accordance with the polarity
markings inside the battery compartment.
Temperature display
• Push on the small tab (see arrow) to open the battery compartment [4].
• Insert two new 1.5V AA batteries in the battery compartment [4] in accordance with the
polarity markings inside the battery compartment.
• Snap the battery cover back in place.
Remote sensor
• Release the screw at the back of the remote sensor an open the battery compartment.
• Insert two new 1.5V AAA batteries in the battery compartment [4] in accordance with the
polarity markings inside the battery compartment.
• After replacing the batteries on the remote sensor, press and hold the channel button [F] for
±2s to clear all previous sensor data. Than press the test button [S3] on the remote senor to
re-establish connection.
• Close the back of the sensor and secure it with the screw.
WARNING:
Dispose of batteries in accordance with local regulations.
Keep batteries away from children.
11. Technical specifications
temperature range
indoor 0°C~50°C
outdoor -20
~60°C
frequency 433MHz
power supply
clock 3 x 1.5V AA batteries (LR6C, not incl.)
sensor 2 x 1.5V AAA batteries (LR03C, not incl.)
dimensions
clock Ø30x4cm
sensor 25x60x95mm
weight
clock ±865g
sensor ±65g
Use this device with original accessories only. Velleman nv cannot be held responsible
in the event of damage or injury resulted from (incorrect) use of this device. For more
info concerning this product, please visit our website www.velleman.eu. The
information in this manual is subject to change without prior notice.
© COPYRIGHT NOTICE
This manual is copyrighted. The copyright to this manual is owned by Velleman nv. All
worldwide rights reserved. No part of this manual may be copied, reproduced, translated or
reduced to any electronic medium or otherwise without the prior written consent of the copyright
holder.