Velleman PCSU200 - Manual (Page 5)

5
SAFETY & WARNINGS
Instruments grounds are interconnected and connected to PC ground. Max. voltage between probe tip and ground: 30V AC+DC at all
times! Before performing any measurement, make sure that the circuit is galvanically seperated from the AC power (mains)!
If necessary, use a safety isolation transformer.
H
OW TO INSTALL
PC-L
AB
200
SOFTWARE
?
Minimum system requirements :
Windows™XP/Vista/7 (*) 32 or 64bit •
VGA display card (1024x768 recommended) •
10MB free hard disk space. •
Mouse or pointing device. •
Free USB port (1.1 or 2.0) •
Download the latest software version from www.velleman.eu
Type PCSU200 in the search box and check the
download section.
Download the PcLAB200_setup.zip fi le •
Unzip the fi les in a folder on your drive •
Double click the “setup.exe” fi le •
An install wizard will guide you trough the complete installation
procedure. Shortcuts to the Pc-Lab200 software can be installed.
(*) Note: You will need local Administrator privileges to successfully complete the installation, contact
your system administrator for assistance. See also the “ReadME” fi le in the installed folder.
*Microsoft Windows™ XP/VISTA/7 (*) are registered trademarks
www.velleman.eu
ax. voltage betwee
e circuit is galvanically s
nnected to PC grou
k th t th
und. Ma
i