Atdec Telehook TH-AN-CM Installation manual - Manual

Dry Wall Anchor
Screw
TM
Component Checklist
Installation Instructions
TELEHOOK
Cable Manager
Wall Plate
10g x 30mm
Screw (x4)
(Check you have received all parts against the Component Checklist below)
End Cap (x2)
Cable Tabs (x8)
A Mount the Wall Plate
Mounting Tips:
Nylon Wall
Plug (x4)
4mm ( 3 /
16
”)
hole
10g x 30mm
screw
Nylon Wall Plug
6mm
( 1 /
4
”)
hole
Wall Plate
Telehook
Cable
Manager
Display
Timber Stud Wall Masonry
Optional Shelf
(sold separately)
Dry Wall
Anchor (x6)
Telehook Cable Manager has been designed to hide the cables of a wall mounted display.
Therefore, it is recommended that it is mounted vertically and centrally below your display.
The adjoining image shows a typical Cable Manager installation.
Ideally, the top of Telehook Cable Manager should sit just under the lower edge of your display
with the bottom of Telehook Cable Manager (i.e. the End Cap) sitting approximately 50mm (2")
above the floor or skirting board.
IMPORTANT: Ensure the lower edge of the Wall Plate is positioned no less than 50mm
(2”) above the skirting board so that there is enough room to accommodate the End Cap
Front Fascia
Tools Required: Power drill 4mm ( 3 /
16
”) drill bit 6mm ( 1 /
4
”) drill bit Phillips head screwdriver
M4 x 5mm Grub
Screw (x4)
Timber Stud
Dry Wall
Mounting
Hole
Pattern
Dry
Wall
Anchor
Mounting
Hole
Pattern
To determine the best position for your Cable Manager, see “Mounting Tips” below
6mm
( 1 /
4
”)
hole
IMPORTANT: For Dry Wall Installation
use alternating mounting holes
10g x 30mm
screw
Masonry
Wall
Dry Wall
2mm Allen Key
End Cap
End Profile
End Profile
Bits Box
It is recommended that your display be installed prior to the installation of this product.
If you wish to paint your Cable Manager, please consult your paint specialist for advice.
Surface finish: Clear Anodised Aluminium
IMPORTANT NOTES
OR OR
Mounting
Hole
Pattern
TH-AN-CM