M-AUDIO MM401 - Manual (Page 8)

Mechanical Installation
To mechanically install the MM-401, do the following:
1. Turn off your computer.
2. Remove the cover and position the computer so you have
easy access to the slots.
3. Select the slot you wish to place your MM-401 card in and
remove the metal bracket that covers the access hole on the
back of the computer.
4. Position the MM-401 card over the slot and fit the card loose-
ly into the slot with the MM-401 card upright. Then press the
card downward into the slot gently but firmly until the card
is seated in the slot. Make sure the card is firmly and square-
ly seated into the slot.
5. Screw the MM-401’s metal bracket into the screw hole inside
the back of your computer.
6. Place the cover back on your computer.
7. Connect the MM-401 MIDI In and MIDI Out cable assembly
to the connector on the MM-401 at the back of the computer.
Use the thumb screws on the cable assembly to attach it to
the connector.
8. If you wish to use the metronome, a cable with an RCA plug
may be plugged into the jack above the MIDI cable assembly
connector. This cable must then be plugged into an amplifi-
er.
9. Attach any MIDI devices you have by connecting your MIDI
cables to the MIDI In and MIDI Out cables of the MM-401.
10. Move your computer back to its original position. You may
now turn on your computer.