VEGA Supplementary electronics Overvoltage protection - Manual (Page 7)

7
4 Mount and connect
Supplementary electronics • Overvoltage protection
46670-EN-140108
4 Mount and connect
4.1 Mounting steps
The supplementary electronics is mounted in the power supply com-
partment. The following illustration shows the position of the power
supply compartment in the double chamber housing.
2
1
Fig. 1: Position of the power supply and electronics compartment
1 Supply room (supplementary electronics)
2 Electronics compartment (sensor electronics)
Proceed as follows:
1. Unscrew housing cover of the power supply compartment
2. Loosen the two holding screws of the supplementary electronics
with a screwdriver (Torx size T 10 or slot size 4)
1
2
5 1 2 + ( ) (-) 6 7 8
Surge
Protection Display
Fig. 2: Power supply compartment with supplementary electronics
1 Supplementary electronics
2 Screws (2 pcs.)
3. Pull the previous supplementary electronics out by using the
dismounting tool.
4. Insert the new supplementary electronics module carefully.
5. Screw in the two holding screws and tighten them
6. Screw the housing cover back on
The supplementary electronics is exchanged.
As a rule, the exchange of the supplementary electronics must be
documented internally when used in Ex applications.
Mounting steps