beautypg.com

3 product description, 1 configuration, 2 principle of operation – VEGA Supplementary electronics For 4 … 20 mA_HART - two-wire and PLICSMOBILE User Manual

Page 5: 3 packaging, transport and storage

background image

5

3 Product description

Supplementary electronics • For 4 … 20 mA/HART - two-wire and PLICSMOBILE

42765-EN-140108

3 Product description

3.1 Configuration

The scope of delivery encompasses:

Supplementary electronics for 4 … 20 mA/HART - two-wire and

PLICSMOBILE

Documentation

– this operating instructions manual

– if necessary, further certificates

3.2 Principle of operation

The supplementary electronics for 4 … 20 mA/HART - two-wire and

PLICSMOBILE is a replacement component for sensors with inte-

grated radio module PLICSMOBILE:

VEGAPULS series 60

– Hardware version from 2.0.0

– Software version from 4.0.0

VEGAFLEX 80 series

VEGABAR series 80

The supplementary electronics contains the radio module PLICSMO-

BILE. It is used for transmission of measured values and for remote

parameter adjustment of plics® sensors via GSM/GPRS.

3.3 Packaging, transport and storage

Your instrument was protected by packaging during transport. Its

capacity to handle normal loads during transport is assured by a test

based on ISO 4180.
The packaging of standard instruments consists of environment-

friendly, recyclable cardboard. For special versions, PE foam or PE

foil is also used. Dispose of the packaging material via specialised

recycling companies.

Transport must be carried out in due consideration of the notes on the

transport packaging. Nonobservance of these instructions can cause

damage to the device.

The delivery must be checked for completeness and possible transit

damage immediately at receipt. Ascertained transit damage or con-

cealed defects must be appropriately dealt with.

Up to the time of installation, the packages must be left closed and

stored according to the orientation and storage markings on the

outside.
Unless otherwise indicated, the packages must be stored only under

the following conditions:

Not in the open

Dry and dust free

Not exposed to corrosive media

Scope of delivery

Area of application

Functional principle

Packaging

Transport

Transport inspection

Storage