VEGA VEGAPULS 65 (≥ 2.0.0 - ≥ 4.0.0) HART and accumulator pack - Manual (Page 55)

55
11 Supplement
VEGAPULS 65 • HART and accumulator pack
40932-EN-121011
Ʋ Max. spectral transmission power
density
+24 dBm/50 MHz EIRP
Ʋ Specific absorption rate (SAR) 0.47 mW/kg
Ambient conditions
Ambient, storage and transport tempera-
ture
-40 … +80 °C (-40 … +176 °F)
Process conditions
For the process conditions, please also note the specifications on the type label. The lower value
always applies.
Process temperature (measured on the process fitting)
Ʋ Process fitting, thread PVDF -40 … +130 °C (-40 … +266 °F)
Ʋ Other process fittings -40 … +150 °C (-40 … +302 °F)
Vessel pressure
Ʋ Screwed part PVDF -1 … 2 bar (-100 … 200 kPa/-14.5 … 29.0 psig)
Ʋ Screwed part and flange 316L -1 … 16 bar (-100 … 1600 kPa/-14.5 … 232 psig)
Vessel pressure relating to the flange
nominal stage
see supplementary instructions manual "Flanges ac-
cording to DIN-EN-ASME-JIS"
Vibration resistance 4 g at 5 … 200 Hz according to EN60068-2-6 (vibration
with resonance)
Shock resistance 100 g, 6 ms according to EN 60068-2-27 (mechanical
shock)
Indicating and adjustment module
Voltage supply and data transmission
through the sensor
Indication LC display in dot matrix
Measured value indication
Ʋ Number of digits 5
Ʋ Size of digits W x H = 7 x 13 mm
Adjustment elements 4 keys
Protection rating
Ʋ unassembled IP 20
Ʋ mounted into the sensor without cover IP 40
Materials
Ʋ Housing ABS
Ʋ Inspection window Polyester foil
Indicating and adjustment elements
Indicating elements
Ʋ Green LED in the supply room Indication of the charging process
Ʋ Yellow LED in the supply room Indication of the charging condition
Adjustment elements
Ʋ Rotary switch in the supply room Selection of the mode