VEGA VEGADIF 65 Electronics module - Manual (Page 8)

2
1
Fig. 3: Loosening the holding screws
1 Electronics module
2 Screws (2 pcs.)
5 Pull the previous electronics out by holding the opening levers.
Note:
Make sure that the housing is not rotated during the electronics
exchange. Otherwise the plug may be in a different position later.
6 Insert the new electronics module carefully. Make sure that the
plug is in the correct position.
7 Insert the two hold screws and tighten them
8 Connect the connection cables according to the operating
instructions manual of the respective sensor
9 Screw the housing cover on
The electronics exchange is now finished.
As a rule, the exchange of the electronics must be documented
internally when used in Ex applications.
8 Electronics module • VEGADIF 65
4 Mounting
36132
-EN
-091210